FADAL CNC 88 Manual

Fadal CNC 88, CNC 88HS and MP-32

Machine Parameters

Strictly speaking it is is not necessary to change any parameters. All that needs configuring is the Baud Rate.
This can be changed by using the CD command, but this change is not retained on power off.
To change using the CD command:
Press the manual key until the ENTER NEXT COMMAND prompt is showing and enter CD, followed by a number
listed below that represents the required baud rate. For example CD,8 would set the baud rate at 9600.
Value
1
2
3
4
5
6
7
8
9
10
To change using the machine parameters
To change the baud rate so it is retained on power off. Press the manual key until the ENTER NEXT COMMAND
prompt is showing and enter SETP. Press ENTER until the Baud Rate parameter is selected. Key in a number
from the above table and then press the ENTER key. Press MANUAL to exit the parameters.

Other Settings

All Fadal controls have the settings detailed below. These are fixed and cannot be changed with the machine
parameters.
Hand Shaking
Parity
Data Bits
Stop Bits
Baud Rate
110
150
300
600
1200
2400
4800
9600
19200
38400
XOn/XOff
Even
7
1