Polygroup Wesley Quick Start Manual

Electrical ratings: 120 V~60 Hz 122.4 W
The supply cord cannot be replaced. If the cord is damaged
the appliance should be scrapped.
Imported by: SERVICIOS HOME DEPOT, S. DE R.L. DE C.V.
Ricardo Margain 605. Santa Engracia, San Pedro Garza García,
Nuevo León, México, C.P. 66267 Phone 01 800 004 6633
Safety Information
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical products, basic precautions should always be
followed, including the following:
READ AND FOLLOW ALL
a.
SAFETY INSTRUCTIONS.
b. This product is for indoor use only. The electrical rating is
120 V~60 Hz 122.4 W.
c. This seasonal product is not intended for permanent
installation or use.
d. Do not mount or place the product near gas or electric
heaters, fireplaces, candles, or other similar sources of heat.
e. Do not secure the wiring of the product with staples or nails,
or place on sharp hooks or nails.
f. Do not let lamps rest on the supply cord or on any wire.
g. Unplug the product when leaving the house, when retiring for
the night, or if left unattended.
h. This is an electric product and not a toy! To avoid risk of fire,
burns, personal injury and electric shock it should not be
played with or placed where small children can reach it.
i. Do not use this product for other than its intended use.
j. Do not hang ornaments or other objects from cord, wire, or
light string.
k. Do not close doors or windows on the product or extensions
cords as this may damage the wire insulation.
l. Do not cover the product with cloth, paper, or any material
that is not a part of the product when in use.
m. Read and follow all instructions that are on the product or
provided with the product.
SAVE THESE INSTRUCTIONS
n.
Pre-Assembly
Package Contents
Part Description
A Tree top, tag 3
B Tree center, tag 2
C Tree bottom, tag 1
D Tree stand
Assembly
Assembling the tree stand
Step 1. Choose a location near a wall outlet.
Step 2. Unfold the legs of the tree stand (D) and lay the stand on
the floor.
Step 3. Slide the locking disk of the tree stand (D) down until it
snaps into place.
Assembling the tree
Step 1. Remove the protective caps from the tree bottom and insert
the pole into the tree stand.
Step 2. Continue by inserting the upper tree section(s) to the lower
section(s) until inserting the tree top.
Step 3. Shape the branches to your preference by working from the
bottom to the top. When adjusting branches, ensure that all
wires are free of branch hinges.
Step 4. Connect the light strings as per the color labels indicated in
attached photo and insert green label plug into the wall
outlet.
Step 5. When finished shaping the branches, slightly upsweep all
branch tips for a uniform look.
Section 2
Quantity
1
Section 1
1
1
1
Model: TG76M5412C03; 131194
Top view
Tree top
S50
S50
S100
S100
Wesley Tree
Side view
Assemble
Red Labels
Together
Assemble
Yellow Labels
Together
Insert
Green Label
Plug Into Wall
Outlet