Party Warehouse Frame Marquee Instructions

3m x 6m Frame Marquee Instructions
Thank you for choosing a Party Warehouse Marquee for your event. Some Basic
Rules:
Please do not drag or walk on any marquee sections
Please do not stick adhesive tape to the walls. This leaves a residue which
is difficult to remove. Use the poles if you wish.
Please do not light fires, including braziers, close to the marquee. Do your
best to ensure the marquee is up wind of any fire however small, as the
smoke and ash will stain the marquee. If using heaters ensure that direct
heat is not applied to the marquee roof or walls.
TAKE CARE!! If you are unsure on anything, please do not hesitate to
contact us, we will be happy to guide you through any stage of the set up
process.
Have a good time as that is what the marquee is there for. How ever just
apply common sense and ensure that party goers do the same. The
material is a high quality PVC and is highly durable; however excess
weight or sharp objects will cause it to tear.
Marquee Roof Assembly
Frame:
Step 1 - Construct the roof frame as per the diagram on page 3, making
sure the eyelets on the eave rails face the corners and face down.
Skin:
Step 2 – Attach the three roof skins to the roof frame, by draping them
over the roof, velcro the sections together (zips not needed). Then pull the
roof skin taught over the corners.
Step 3 –One person needs to go underneath the roof, using the straps
attached to the roof skins to the eave rails. Depending on the wind
conditions you should only need to attach the roof in the corners. If there is
a wind situation additional straps will need to be attached to secure the
roof safely.
3m x 6m Frame Marquee Setup Instructions – Party Warehouse. Page 1 of 3