Adp ANTONIO METAL FRAME VANITY Installation Instructions Care & Maintenance

ANTONIO METAL FRAME VANITY

INSTALLATION INSTRUCTIONS

CARE & MAINTENANCE

PRIOR TO INSTALLATION

INSTALLATION INSTRUCTIONS

DRAWER ALIGNMENT & INSTALLATION

CARE & MAINTENANCE

ADP WARRANTY

PLEASE RETURN TO HOME OWNER - IMPORTANT CARE & WARRANTY INFORMATION INSIDE.

For more information visit www.adpaustralia.com.au.

ARE YOU INSTALLING THIS PRODUCT?

Please read the installation instructions BEFORE INSTALLATION.

If the product is not installed in accordance with these instructions, your ADP

warranty may be void and the homeowner may have a claim against you

(the installer).

This product must be installed by a qualified tradesperson.

I M P O RTA N T - It is the responsibility of the installer to make

any adjustments to doors/drawers after installation if required.

There may have been some movement in transportation and installation which causes

doors/drawers to become unaligned.

Table of Contents

Need help?

Do you have a question about the ANTONIO METAL FRAME VANITY and is the answer not in the manual?

Page 1 ARE YOU INSTALLING THIS PRODUCT? Please read the installation instructions BEFORE INSTALLATION. If the product is not installed in accordance with these instructions, your ADP warranty may be void and the homeowner may have a claim against you (the installer).
Page 2: Important Tips
Please Note: If you cannot find the installation instructions for your ADP product in this booklet please go to www.adpaustralia.com.au/installation-warranty to find applicable instructions.
Page 3 Fix metal frame to wall through top rail Pre-drill and fix metal frame to wall through I N S TA LL ATIO N IN STRUC TIO N S: AN TO NI O M ETAL FRAM E bottom rail For FLOOR MOUNT installation go to Step 4 Support Beam Location Support Beam WALL HUNG: Once the wall...
Page 4: Care And Maintenance
INSERTING DRAWER • ADP products are produced from materials that are well suited to the bathroom, however it is important that your bathroom has sufficient ventilation to avoid excessive moisture. High humidity will lead to permanent dampness and mould, resulting in deterioration of the materials.
Page 5: Warranty
In the event of a call out for issues covered under the ADP manufacturer warranty, no call out fees will apply. If ADP is called out and the cause of the issue falls within the warranty exclusions or the installation instructions have not been adhered to, the following charges will apply: Call out fee: $198.00 initial cost, first 15 minutes included.