Advertisement
FT Series
Fans
Assembly of Blade and Grilles:
• Unscrew the spinner clockwise and the nut counter clockwise then remove both of them with the plastic sleeve around motor
shaft.
• Set the rear grille in the proper position with handle facing upwards.
• Screw on plastic nut tightly to attach grille.
• Discard sleeve on shaft.
• Install the blade onto the shaft until it reaches the retaining pin.
• Screw spinner on to motor shaft counter clockwise.
• Mount the front grille and fix both grilles together with clips.
Operating Instructions:
• To make/stop the fan head oscillate, push down/pull the clutch knob on the motor housing.
• To adjust vertical angle, tilt fan head up or down as desired.
• Speed is controlled by depressing the piano keys.
• Plug the power supply cord into wall outlet.
Cleaning:
• Be sure to unplug from the electrical supply source before cleaning.
• Plastic parts should be cleaned with mild soap and a damp cloth or sponge. Thoroughly remove soap film with clean water.
• To disassemble each part, reverse the order of assembly.
If the supply cord is damaged, it must be replaced by the manufacturer or services agent in order to avoid hazard.
Part Number Table
Description
Fan, 9 Inch Desk
Fan, 12 Inch Desk
Fan, 16 Inch Desk
Part Number
FT-0907
FT-1207
FT-1607
Page 2
21/06/06 V1.0
Advertisement
