Using Your Ice Maker - Euhomy IM-F Instruction Manual

Hide thumbs Also See for IM-F:
Table of Contents

Advertisement

USING YOUR ICE MAKER

Operation panel and display area
1. Remove the cover of the water reservoir and pour potable water into water reservoir.
And be sure to keep water level below the max. level with FULL mark displayed in following
Then move back the cover at once to avoid foreign matter enter.
picture.
Warning: Do not pour the water into the internal water tank located underneath
the ice basket. This tank is not big enough and will effect the ice making
performance.
2.
When you plug the unit, the power symbol<
the unit will start making ice cube, ice making symbol<
corner
of display area will show the ambient temp,i.e:80℉ means the ambient temp is 80
℉.After several mins, this area will show flash number, the ice making will countdown,i.e:10M
means the ice making will finish 10 mins later.
3. When ice maker harvest,symbol<
bottom water tank through solenoid valve,the symbol <
the bottom water tank is full,the symbol <
start again.When there is no water in the water reservoir, the symbol <
Turn off the unit and fill water again, then restart the unit to make ice cube.Or fill water
directly and wait 20mins,the unit will restart .
Remark:The ice making cycle lasts about 13 to 25 minutes, depending on the ambient
temperature. And for the first time, according to the initial water temperature, ice-making last time
will be a little longer. In the extreme hot room temperature, ice-making time may be
Vary a lot, but it will not exceed35minutes.
If you think the ice cube is not thick enough, during ice making,press the<+>and<->to
set the ice making lead time. Press one time and the ice making cycle will in crease or
Reduce one min,6minmost.This can only start from the new cycle.
TIMER
ON/OFF
Cover for the
water reservoir
> flash, the water will flow from top water reservoir to
OPERATION AREA
+
-
> will flash. Press the <ON/OFF>button,
> will keep running. The left up
> will be on ,when the water in
> will be off,then the next ice making cycle
8
DISPLAY
AREA
> will keep on.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IM-F and is the answer not in the manual?

Table of Contents