Table of Contents
Advertisement
Temperature Screening procedure
1.
Tap NFC card on the NFC Sensor if you would like to record detection with your
personal detection (if applicable)
2.
Move your head towards the Smart Thermal Scanner until your face covered most
area of the human shaped frame of the detection area (The distance between
device and a user whose height 140cm to 180cm is recommended to be 30 cm.
User may slightly move forward and backwards to improve the quality of facial
image capture) Detection area will shows a scanning animation when the distance
is appropriated. If no scanning animation is shown, move your head closer to the
machine. The Screening will start immediately once the animation is shown. (Note:
During enrolment and verification, please remain nature face expression and
standing posture.)
3.
Try to keep the face in the centre of the screen during registration. Please face the
face infant of the camera stay still wait for 1 seconds until the face register and
display shows the screening result.
4.
Display shows below screening result regarding to the use body temperature
32°C - 37.3°C
(89.6°F - 99.1°F)
GREEN
Normal Body Temperature
Temperature Screening Hints
To ensure temperature screening result accurate, please avoid below environment factors
Factors
Room temperature too high / too low
Obstruction found between the face and the measuring device
Measuring too far
Users should avoid measuring temperature in the cases below, wait for 20 minutes before measuring the temperature
Situation
After intense exercise
After hot bath
After long time exposure to directly sunlight
Wearing too many clothes / not enough cloths
PANTUM MALAYSIA SDN BHD
37.4°C - 38°C
(99.2°F - 100.4°F)
YELLOW
Mild Fever
Effects
Deviations will be found in measuring result
Measure unsuccessfully
Inaccurate measuring result
Effects
Measure result will be high
Measure result will be high
Measure result will be high
Measure result will be high / low
Page 6
Note: The distance between device
and a user whose height 140cm to
180cm is recommended to be 30
cm. User may slightly move forward
and backwards to improve the
quality of facial image capture
38.1°C - 42°C
(100.5°F - 107.6°F)
RED
High Fever
SMART THERMAL SCANNER
USER MANUAL (Version1.0)
Copyright © 2020 mypantum.com. All rights reserved
Advertisement
Table of Contents
