1.5 REAR SUSPENSION LAYOUT
Top Wishbone
Roll Bar
Spring/Damper
Pushrod
Driveshaft
Lower Wishbone
1.6 ELECTRICAL HARDWARE LOCATION
On the right-hand side of the SR3 cockpit you will find an access panel, behind this are the following items:
o ECU
o Barometric pressure sensor
To remove the ECU, undo the 4 bolts holding the plate on, then the two bolts in the bracket for the ECU.
pull the silver clip upwards to an upright position. The connecting hairbrush can then be rotated off the ECU.
To refit repeat these steps in reverse. This should not be removed unless there is an issue or the engine is
being returned for rebuild.
Rocker
Upright
8
Then
QD163-1