3D Fun Printz Cameo 4 Universal Pen Holder Instructions
  1. Manuals
  2. Brands
  3. 3D Fun Printz Manuals
  4. 3D Printers
  5. Cameo 4 Universal Pen Holder
  6. Instructions

3D Fun Printz Cameo 4 Universal Pen Holder Instructions

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

Cameo 4 Universal Pen Holder Instructions
Thank you for purchasing the 3D Fun Printz Pen Holder
There are some tips below to get the best out of it.
Most importantly. The Pen Holder is partly made from PLA as it is a natural plastic
originating from corn starch and is recyclable. For these reasons it does not like heat.
Please don't leave it in the sun, on a hot windowsill, on or near a radiator or anywhere else
with a lot of heat.
Please also keep away from children and animals. PLA can be sharp when broken.
NEVER TRY AND ADJUST THE SCREW CAP WHILE THE HOLDER
IS IN YOUR MACHINE. YOU WILL DAMAGE YOUR MACHINE.
ALWAYS FULLY REMOVE THE HOLDER BEFORE ADJUSTMENT.
DO NOT FLEX THE TIPS BY HAND. THEY ARE DESIGNED TO
MOVE VERY SLIGHTLY TO ACCEPT A PEN NIB. FORCING A PEN
BODY ALL THE WAY THROUGH THE TIP OR FLEXING THEM BY
HAND MAY BREAK THEM
To fit a pen into the holder clip the alignment clip onto the holder as shown. It should
remain loosely in place without holding. There are tabs that fit into the holes on the pen
holder

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cameo 4 Universal Pen Holder and is the answer not in the manual?

Questions and answers

Summary of Contents for 3D Fun Printz Cameo 4 Universal Pen Holder

  • Page 1 Cameo 4 Universal Pen Holder Instructions Thank you for purchasing the 3D Fun Printz Pen Holder There are some tips below to get the best out of it. Most importantly. The Pen Holder is partly made from PLA as it is a natural plastic originating from corn starch and is recyclable.
  • Page 2 Unscrew the top cap most of the way, but not all the way Insert your pen so the nib just touches the recess inside the alignment clip as below. You may need to wiggle the pen slightly to spread the flexible grips. While gently holding the pen in place screw the top cap down so the flexible inserts retract into the holder and grip the pen.
  • Page 3 You may need to adjust the draw pressure on your machine to get satisfactory results. To remove the pen unscrew the lid most of the way and pull the pen out gently. You may need to wiggle the pen gently in a circular motion to release the grip mechanism. When not in use do not leave a pen in the holder and try not to screw the lid all the way down for storage.
  • Page 4 Care of your Universal Pen Adapter Due to the way the grip mechanism works it may require lubricating periodically. If the mechanism feels stiff or “gritty” when you screw the cap down then it is time for a little lubrication. Unscrew the cap all the off the pen holder and place to one side.

Table of Contents