Advertisement
Unpacking
Open the carton containing the glove box holder and the mounting hardware. Remove all
packing material. You should have the following components:
QTY
PART NO.
1
2
6021-1511
2
6030-0500
Tools Required
y Drill
Installation
1. Determine the desired location and height of
where the glove box holder is to be mounted.
2. Place the holder against the wall. Insure it is
level and mark the holes to use to mount the
holder.
3. Remove the holder and drill two 1/4" diameter
holes for the mounting wall anchors.
4. Insert the wall anchors in the wall until they are
flush with the wall.
5. Insert the screws into the anchors and then
tighten the screws until about a 1/8' gap is
between the screw head and the anchor.
6. Align the large end of the slotted holes in the
holder over the screw heads and pull down to
secure the holder to the wall.
7. The glove box holder is now ready for use.
FULL FRAME GLOVE BOX HOLDER
MOUNTING INSTRUCTIONS
PLEASE READ THROUGH INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
GH SERIES FULL FRAME GLOVE BOX HOLDER
SCW PAN HEAD, SHEET METAL #10x1.5, PHILIP DR,
ZINC PLATE, FASTENAL #31366
ANCHOR, WALL PLUG FOR #10x1-1/2" SCREW, SOLID
WALL ANCHOR AF6-1/4, FASTENAL #50945
y 1/4 Drill Bit
GH SERIES
IMPORTANT!
DESCRIPTION
y #1 Philip Screwdriver
1 Box Mounting Dimensions
Advertisement
