Contents Unpacking ............................4 Product Overview ..........................5 Main Unit .....................................5 Control Panel ..................................6 Remote Control .................................7 Moving the Unit ...........................7 Battery Replacement for the Remote Control ...................8 Filling the Water Tank ..........................9 Draining water out from the water tank (if necessary) ..................10 General Operation ..........................11 Switching the Unit ON/OFF ............................
Thank you for purchasing your new product. We recommend that you spend some time reading this instruction manual in order that you fully understand all the operational features it offers. You will also find some hints and tips to help you resolve any issues. Read all the safety instructions carefully before use and keep this instruction manual for future reference.
Product Overview Main Unit 1. Control Panel 2. Water Tank 3. Castor 4. Recessed Handle 5. Grille 6. Ice Box Make sure that the grille is installed before switching on the unit. Make sure that the ice boxes are cold enough before putting them into the water tank. You may put the ice box into the freezer for cooling.
Control Panel 1. EVA. / COOLER Button • Press repeatedly to select between Evaporator / Cooler mode. • The indicator lights up in Evaporator mode. • The indicator flashes while there is a shortage in the water tank. Refill the water tank at the rear of the unit.
Remote Control SPEED Button Press repeatedly to switch the wind speed between high / medium / low level. Evaporator/Cooler Button Press repeatedly to select between Evaporator/Cooler mode. SWING Button Press repeatedly to switch oscillation on/off. Wind Type Button Press repeatedly to switch between Natural Wind or Steady and Slow Wind mode.
Battery Replacement for the Remote Control The remote control requires a CR2032, 3V battery. 1. Slide and hold the battery release tab in the direction of the arrow. 2. Pull out the battery holder and remove the old battery. 3. Replace with a new battery. 4.
• Do not ingest battery. Chemical Burn Hazard. • This product contains a coin / button cell battery. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. •...
Draining water out from the water tank (if necessary) The water filled in the water tank is for air cooling operation. Once when there is a shortage in the water tank, the Evaporator indicator will flash. 1. Slide the water tank out from the main unit. 2.
General Operation Switching the Unit ON/OFF Press ON/OFF button on the unit or remote control to switch the unit on/off. • • To completely switch off the unit, unplug from the mains supply. Setting Evaporating / Cooling Mode Press EVA. / COOLER button on the unit or Evaporator/Cooler button on the remote control to select between Evaporator or Air Cooler mode.
Cleaning and Maintenance Make sure to unplug the unit before cleaning and maintenance. Cleaning the Exterior • Use a soft cloth to wipe down the exterior. • Do NOT use any abrasive cleaning agents or detergents. • Do NOT immerse any part of the unit in water or any other liquid. Cleaning the Grille and Filter 1.
If problem(s) persists, contact a qualified service agent for assistance. Specifications Brand Logik Model L48ACW20 Rated Voltage 220 – 240V~ Rated Frequency 50 Hz Rated Power 50 W Maximum Fan Flow Rate (F) 4.26 m...
Need help?
Do you have a question about the L48ACW20 and is the answer not in the manual?
Questions and answers
is it normal for fan to be on for short time then stop and then restart and repeat this process
Where can I get replacement filters