Pairing A Transmitter (Handset) And A Receiver; Clearing The Receiver Memory - Promatic RTM1 Operating Instructions

Table of Contents

Advertisement

Pairing a transmitter (handset) and a receiver .

Each Receiver can be paired to operate with up to 8 handsets, for best results the
handset and receiver should be within 2 Meters of each other whilst pairing.
Make sure that no other PROMATIC radio transmitters are operating
within 300 Metres of the receiver being paired. This will avoid acci-
dentally pairing a receiver to another radio operating elsewhere which
could lead to unpredictable and undesirable operation.
Plug the receiver into a trap, connect the trap to the battery & turn the isolator to
the on position to provide power to the receiver (The trap does not need to be
armed - however take note of trap safety warnings) .
A symbol on the receiver's rear label shows the magnet sensor position
to be used when pairing with a handset, place a magnet (Cartridge pick
-up stick etc..) on the small magnet symbol, you will hear an initial
beep, hold for a second or so until you hear a short 2 tone beep, then
remove the magnet. You are now in pairing mode and have approxi-
mately 10 seconds to pair a handset to the Receiver, as outlined below.
SP1 (Single) Handset with 1 receiver:
With the receiver in pairing mode, press and hold the fire button. After about 5 sec-
onds, the receiver should give a short tone to confirm that it has accepted the pair-
ing, at this point release the button.
SP2 (A-Hi / B-Lo / Pair) Handset with 2 receivers:
Pair the first receiver as above then repeat using the other button to pair the second
receiver. The Pair (A & B) button will work automatically.
ABT Handset with 3 channel receiver:
With the receiver in pairing mode, press and hold the fire button. After about 5 sec-
onds, the receiver should give a short tone continue to hold until a second beep is
heard, the receiver has now accepted the pairing, at this point release the button.
The Rotation and/or Elevation buttons will have followed and work automatically.
After pairing any handset & receiver you should test fire the trap a few times to
confirm that the desired pairing is working correctly.

Clearing the receiver memory:

Place the magnet on the small magnet symbol as before but this time hold for ap-
prox. 10 seconds until a rapid beeping sound is heard and then remove the magnet.
The receiver is now de-programmed and will give a repeating pulse tone as long as it
powered up to indicate this. It will no longer respond to any handset until paired.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RTM1 and is the answer not in the manual?

Table of Contents

Save PDF