Visual Productions B -STATION1 Manual page 8

B-Station1
4 label sheets
Figure 1.2: B-Station1 box contents
1.3 Saving data to memory
This manual will describe how to configure the B-Station1 and program cuelists,
action, etc. The unit's web-interface is used for editing these kinds of elements.
When changes are made, these changes are directly stored in the RAM memory
of the B-Station1 and the programming will directly influence the behaviour of
the unit. RAM memory is, however, volatile and its content will be lost through
a power cycle. For this reason the B-Station1 will copy any changes in the RAM
memory to its onboard flash memory. Flash memory retains its data even when
not powered. The B-Station1 will load all its data back from the flash memory
upon startup.
This memory copy process is conducted automatically by the B-Station1 and
should not be of any concern of the user. One point of consideration is, however,
that after making a change the unit should be given time to perform the copy to
flash. As a rule of thumb, do not disconnect the power from the device within
30 seconds from making a programming change.
1.4 Further Help
If, after reading this manual, you have further questions then please consult
the online forum at http://forum.visualproductions.nl for more technical
support.
8