Landscape Forms Outdoor Power Installation Manual

Outdoor Power
Installation Guide
Included components
Charging station
Power
with accent light
Pedestal
Tools Required
• Safety glasses
• Wrenches, 1/2", 9/16"
• Socket wrench, 7/16"
• Screwdrivers, Phillips and straight blade
• Wiring tools and connectors
• Level
• Grease
Power Pedestal and Outdoor Charging Station with Accent Light
4X – Rubber cap
1X – Wire Nut
ASSEMBLE WITH CARE! To protect this finish during assembly, place
unwrapped powder coated parts on packaging foam or other non‐marring
surface. Do not place or slide powder coated parts on concrete or other
hard or textured surface – this will damage the finish causing rust to occur.
Use touch‐up paint on any gouges in the finish caused by assembly tools.
Landscape Forms is not responsible for site preparation and
1X – Warning Label
footings. Refer to the installation guide for the Outdoor Power
anchor kit for installing the anchor bolts.
IMPORTANT! Please read all instructions before beginning
installation.
Legrand Electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire hazard if
improperly installed or used. Legrand electrical products may bear
the mark of a nationally Recognized Testing Laboratory and should
be installed in conformance with current local and/or the National
Electrical Code.
Date: June 10, 2016
www.landscapeforms.com Ph: 800.521.2546
Page 1 of 8