Download Print this page

Advertisement

Quick Links

Quick installation guide
v1.0
EN
Quick installation guide
DE
ES
PT
EL
FI
RU
HU
TR
AR
470805
controlled comfort

Advertisement

loading
Need help?

Need help?

Do you have a question about the 470805 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SLV 470805

  • Page 1 Quick installation guide v1.0 Quick installation guide 470805 controlled comfort...
  • Page 2 Read the “important information” booklet before installing this product Not following the safety instructions may be dangerous and faulty installation will invalidate any warranty that may apply to this product.
  • Page 4 Connect lamp/device and place receiver First check if the lamp or device is turned on. Then plug the lamp or device into the receiver and plug the receiver into a socket. Do not exceed the maximum load: 3500 W.
  • Page 6 1 sec. Activate learn-mode Press the learn-button on the receiver for 1 second. The learn-mode will be active for 15 seconds, during which the LED- indicator will blink slowly.
  • Page 8 Assign SLV transmitter code While the learn-mode is active, send an ON-signal with any SLV CONTROL trans- mitter to assign the code to the receiver’s memory.
  • Page 10 Code confirmation The receiver will switch on/off 2 times to confirm the code has been received. The receiver can store up to 6 different transmitter codes in its memory. The memory will be preserved when the receiver is moved to another socket or in case of power failure.
  • Page 12 Manual operation with a SLV transmitter (1) Press ON to switch the receiver on. (2) Press OFF to switch the receiver off.
  • Page 14 The learn-mode will be active for 15 seconds, during which the LED-indicator will blink slowly. (2) While the learn-mode is active, send an OFF-signal of a specifi c SLV transmitter to delete that code. (3) The receiver will switch on/off 2 times to...
  • Page 16 Full memory delete 7 sec. 1 sec. Full memory delete: (1) Press and hold the learn-button of the receiver (approx. 7 sec.) untill the LED-indicator starts blinking fast. The delete mode will be active for 15 seconds. (2) While the delete mode is active, press the learn-button again for 1 second.