Do you have a question about the PR-100 and is the answer not in the manual?
Questions and answers
albert podgorelec
March 19, 2025
Nemorem je uporabljati saj mi ne dela sem vstavil nove baterije,sd.kartico in odstranil zascitno folijo zgoraj in spodaj,na sredini pa je nega,prosim za pomoc Hvala
1 comments:
Mr. Anderson
May 14, 2025
If the ACAMPTAR PR-100 is not functioning after inserting new batteries and an SD card, take the following troubleshooting steps:
1. Ensure the batteries are correctly inserted with proper polarity (+/-). 2. Confirm the batteries are fully charged or new. 3. Verify that the SD card is properly inserted and formatted correctly. 4. Check that the SD card is not locked (write-protected). 5. Make sure the power switch is set to the correct position (e.g., ON or TEST). 6. Ensure the time.txt file, if used for settings, is in the correct format and saved to the SD card root. 7. If changes are made to the time.txt file, turn the switch to OFF and disconnect the power before reinserting the card.
If the device still does not work, check for hardware damage such as a burned or cracked PCB, as this may void the warranty.
Need help?
Do you have a question about the PR-100 and is the answer not in the manual?
Questions and answers
Nemorem je uporabljati saj mi ne dela sem vstavil nove baterije,sd.kartico in odstranil zascitno folijo zgoraj in spodaj,na sredini pa je nega,prosim za pomoc Hvala
If the ACAMPTAR PR-100 is not functioning after inserting new batteries and an SD card, take the following troubleshooting steps:
1. Ensure the batteries are correctly inserted with proper polarity (+/-).
2. Confirm the batteries are fully charged or new.
3. Verify that the SD card is properly inserted and formatted correctly.
4. Check that the SD card is not locked (write-protected).
5. Make sure the power switch is set to the correct position (e.g., ON or TEST).
6. Ensure the time.txt file, if used for settings, is in the correct format and saved to the SD card root.
7. If changes are made to the time.txt file, turn the switch to OFF and disconnect the power before reinserting the card.
If the device still does not work, check for hardware damage such as a burned or cracked PCB, as this may void the warranty.
This answer is automatically generated