PSP H1-75-04N Installation Instructions

Advertisement

H1-75-04N Installation Instructions
Surge Protection Device 120/240 Volt AC Type 1
Installation Instructions
1. To assure proper installation measure the voltage on each phase and insure the correct device is installed.
2. Turn off power to circuit where surge protector is to be installed.
3. Mount device so as to keep conductor length as short as possible. Cut wires to length and connect to circuit per wiring diagram below
avoiding sharp bends or looping.
4. Reinstall covers, restore power and confirm diagnostic LED is Illuminated.

120/240 Vac Installation Diagram

120V ac
Black
240V ac
120V ac
Green
Black

Diagnostic Operation

LED On = System Protected
LED Off = Replace Device
Disconnect
Ground
Black
www.pspproducts.com
Line 1
Ground*
Line 2
Green
Black
*All surge protection devices require good ground
connection for effective operation
Phone: 800-648-6802
PSP Products Inc. - 8535 Phoenix Drive, Manassas, VA 20110
120 Vac Installation Diagram
Black
120V ac
Green
Black

Device Ratings

Normal Voltage Per Leg
Max. Operating Voltage (MCOV)Per Leg
Max. Discharge Current (Imax)
Nipple mount to enclosure for type one installation
Service Panel
Ground
sales@pspproducts.com
Fax: 703-393-9101
Line
Ground*
Neutral
120 Vac
150 Vac
75 kA
Black
Green
Neutral
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H1-75-04N and is the answer not in the manual?

Questions and answers

Summary of Contents for PSP H1-75-04N

  • Page 1 Nipple mount to enclosure for type one installation Disconnect Service Panel Black Ground Green Green Black Black Ground Neutral *All surge protection devices require good ground connection for effective operation www.pspproducts.com Phone: 800-648-6802 sales@pspproducts.com Fax: 703-393-9101 PSP Products Inc. - 8535 Phoenix Drive, Manassas, VA 20110...
  • Page 2 $50,000 Connected Equipment Warranty Under the terms of this warranty PSP Products Inc. Will repair or replace any motor or electro mechanical component of the connected HVAC system that is damaged as a result of a surge passing through our device. We will pay up to $1,000.00 per occurrence with a $50,000 lifetime maximum.

Table of Contents