Advertisement
module
explained
SALUT
Thank you for purchasing this Xaoc Devices
product. Poti is a simple but useful break-
out expansion for the ever popular Batumi
quadruple low frequency oscillator module.
To find out more about Batumi and other
Xaoc Devices products, please visit
xaocdevices.com.
INSTALLATION
Poti is compatible with all the Batumi revi-
sions and there is no need to update the Ba-
tumi firmware to use the expander module.
The installation is simple, however, please
first read through the following steps:
1. Find the cluster of jumper pins
the back of Batumi.
2. Remove all the jumpers (you may want
to save them for later use).
3. Plug the Poti ribbon connector
the jumper pins so that the red stripe or
mark points down.
Connecting the cable in a wrong way will
not cause any damage, but the switches will
not operate as intended and won't match
the waveform selection legend printed on
the faceplate.
4. After properly connecting the modules
together, carefully put them back in
your case, plug Batumi's power connec-
tor into the busboard aand fasten using
the provided screws.
Poti does not require its own power connector.
caution:
power connector with the expansion cable!
Doing so will likely damage Batumi and
void the warranty.
FEATURES & OPERATION
Poti provides immediate access to the Batu-
mi functions originally selected by the clus-
www.
ter of jumpers on the back of the module:
reset/sync mode and the selection of the
assignable waveform (asgn).
The upper switch
reset and tap-tempo function of Batumi's
reset/sync inputs.
The combination of the two lower asgn
switches
to the saw/asgn outputs, as per the mark-
1
on
ings on the Poti panel.
Please refer to the Batumi manual for de-
tails about modes and functionality. •
2
into
3
Be careful not to confuse the
3
toggles between the
4
select the waveform delivered
Your M3 screws
Advertisement
