Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Bespoke Rugby Scoreboard
- Page 1 Set up and operating instructions Rugby Scoreboard...
- Page 2 Introduction The Rugby scoreboard is used to display the match score and match time. The display digits are available as 6, 9, 11, 13 and 16 inch tall digits, allowing your club to choose the digit size to suit your clubs needs.
- Page 3 Power on The scoreboard unit does not have an on/off switch, therefore it will turn on when power is plugged in. If your system uses a remote controller, either wired or wireless, then the controller is turned on by pressing the power button on the face of the controller. Remote controller fascia Timer operating instructions Start/Stop Button...
- Page 4 intervals by pressing either the ‘ + ’ or ‘ - ’ buttons. It will take approximately 2 seconds of holding down the reset button before the time can be adjusted. On a remote controller, the reset LED illuminates along with the timer setting display, when the time can be adjusted If the timer is reset to zero (00:00), it will count upwards when operated.
- Page 5 Wireless Transmitter When using a wireless remote controller, ensure the aerial is connected to the wireless transmitter output socket (BNC) and rotated to be in a vertical position. There will be a delay of approximately two seconds, following the controller being switch on, before data is transmitted from the control panel to the scoreboard.
- Page 6 The receiver power LED indicates there is power on the Receiver PCB inside the scoreboard. The data input power LED indicates there is power on the Data Input PCB inside the scoreboard. The data LED will flash each time the scoreboard receives data from the controller. If the Data LED stops flashing then it is no longer receiving data.
- Page 7 Controller charging LED sequence Initial Battery Test Fast Charge Fully Charged When the batteries have been very heavily discharged, it may take much longer for the fast charge to start. If the battery charger detects that a battery is faulty, then the charge will stay at the battery test stage until the fault is corrected.
- Page 8 Please call and discuss any issues you may have with your scoreboard. We will be able to guide you to test and diagnose any faults with your system. Spares and prices are available on our website. Bespoke Scoreboards are designed and made in England by M-Jay Electronics Limited phone:...
Need help?
Do you have a question about the Rugby Scoreboard and is the answer not in the manual?
Questions and answers