Subscribe to Our Youtube Channel
Summary of Contents for Dolphin Blue 620
- Page 1 INSTALLATION AND MAINTENANCE GUIDE DB620 /DB625 P R O X S E N S O R K I T Important: Read carefully before installing product March 2018...
- Page 2 INDEX Technical Data Pre-Installation Info Installation 9-11 Settings Adjustment with remote control Maintenance Filter Cleaning Instructions Care and cleaning of chrome and special finishes Trouble Shooting Limited warranty DB620 / DB 625 Dolphin...
-
Page 3: Technical Data
0.5-8.0 bar (7-116 PSI). With water pressure pressure of more than 8 bars, use a pressure reducing valve Hot water temperature Max 70°C Min. sensor range 30mm / 1.18” Max. sensor range 300mm / 1.81” DB620 / DB 625 Dolphin... -
Page 4: Preparation For Installation
All plumbing is to be installed in accordance with applicable codes and regulations. Operation Once the kit is installed and connected to the water supply: Water will be delivered automatically when the user leaves the sensor range after using the urinal. The water flow DB620 / DB 625 Dolphin... - Page 5 4. If your system is provided with an inlet nipple, fit the water supply inlet to the inlet nipple at the solenoid valve housing or connect it directly to the shut off valve. DB620 / DB 625 Dolphin...
- Page 6 Connect the waterproof connector coming from the prox sensor to the transformer. b. Plug the transformer into the electrical socket. Important: In order to avoid going into adjusting mode, wait 10 seconds before operating the system. DB620 / DB 625 Dolphin...
- Page 7 4. Connect the water outlet to the solenoid valve housing. DB620 / DB 625 Dolphin...
- Page 8 3. For transformer models: a. Connect the waterproof connector coming from the prox sensor to the transformer. b. Plug the transformer into the electrical socket. Important: In order to avoid going into adjusting mode, wait 10 seconds before operating the system. DB620 / DB 625 Dolphin...
-
Page 9: Settings Adjustment
At this stage, you can change the setting by pressing the (+) or the (-) buttons, every push will increase or decrease one level. After finishing the adjustment, turn the water supply back on. DB620 / DB 625 Dolphin... - Page 10 (for example, cleaning). The product will remain shut for 1 minute when this button is pressed once. To cancel this function and to return to normal operation press the On/Off button again or wait 1 minute. DB620 / DB 625 Dolphin...
- Page 11 The pre-programmed flush cycle will take place then. The Comfort flush cannot be interrupted or deactivated by pressing any button until it is over. DB620 / DB 625 Dolphin...
-
Page 12: Maintenance
For surface cleaning of the sensor unit use ONLY soap and water, then wipe dry with clean cloth or towel. When cleaning bathroom tile, the unit should be protected from any splattering of harsh cleansers. DB620 / DB 625 Dolphin... -
Page 13: Troubleshooting
. LED in the sen when u ser s sor i or c ithin ar e the sor’s DB620 / DB 625 Dolphin... -
Page 14: Limited Warranty
If a defect is found in normal use, Dolphin will, at its discretion, repair, provide a replacement part or product, or make appropriate adjustments. - Page 15 Request your 200 page catalogue today on 01424 202224 Dolphin Solutions Ltd Southpoint, Compass Park, Bodiam, Robertsbridge, TN32 5BS Tel: +44 (0)1424 20 22 24 Fax: +44 (0)1424 205 200 info@dolphinsolutions.co.uk www.dolphinsolutions.co.uk...
Need help?
Do you have a question about the Blue 620 and is the answer not in the manual?
Questions and answers