Antenna Assembly - WADE Antenna, Inc. Taco Antenna D4000 Series Instruction Booklet

Assembly
1. Loosen the clamping screws on the antenna. See mounting detail.
ASSEMBLY
2. Pull downleads up through the mounting pipe and make the
connection to the antenna.
1. Loosen the clamping screws on the antenna. See mounting detail.
3. If grounding your equipment, do so at this time by following the Safety
2. Pull downleads up through the mounting pipe and make the
connection to the antenna.
Precautions procedure.
3. If grounding your equipment, do so at this time by following
4. Slide the clamping end of the antenna onto the mounting pipe.
the Safety Precautions procedure.
5. Alternately secure the clamping screws making sure to keep the
4. Slide the clamping end of the antenna onto the mounting pipe.
mounting pipe centred with the antenna.
5. Alternately secure the clamping screws making sure to keep the
6. After final tightening, lock clamping screws into position using the
mounting pipe centred with the antenna.
supplied stainless steel hex nuts.
6. After final tightening, lock clamping screws into position using the
supplied stainless steel hex nuts.
4
Instruction Booklet - D4000 and D5000 Series Omnidirectional
ANTENNA
(5000 Series shown)

ANTENNA ASSEMBLY

ANTENNA ASSEMBLY
CLAMPING SCREW
MOUNTING PIPE
(MAST)
3