Mattel Hot Wheels Motorized Tornado Twister Instructions
Mattel Hot Wheels Motorized Tornado Twister Instructions

Mattel Hot Wheels Motorized Tornado Twister Instructions

Track set

Advertisement

BATTERY SAFETY INFORMATION:

CONSUMER INFORMATION
Keep these
instructions
for future
reference, as
they contain
important
information.
We are dedicated to quality products.

TWO-YEAR LIMITED WARRANTY

YOU CAN TELL IT'S MATTEL!
CALL us toll-free
or write with any comments or questions about
our products or service. Monday-Friday, 8:00
a.m.-6:00 p.m. Eastern Time. Outside U.S.A., see
telephone directory for Mattel listing. Consumer
Relations, Mattel, Inc., 333 Continental Blvd.,
El Segundo, CA 90245 USA
1 ( 800 ) 524-TOYS
CONFORMS TO THE SAFETY
REQUIREMENTS OF ASTM F963.
INSTRUCTIONS
ADULT ASSEMBLY REQUIRED.
(not included

CONTENTS:

F
E
6
(not included).
D
C
B
3
5
2
4
A
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hot Wheels Motorized Tornado Twister and is the answer not in the manual?

Questions and answers

Summary of Contents for Mattel Hot Wheels Motorized Tornado Twister

  • Page 1 Monday-Friday, 8:00 a.m.-6:00 p.m. Eastern Time. Outside U.S.A., see for future telephone directory for Mattel listing. Consumer Relations, Mattel, Inc., 333 Continental Blvd., reference, as El Segundo, CA 90245 USA they contain...
  • Page 2 INSTALL BATTERIES Attach Labels TO REMOVE and Accessories BATTERIES to tower. O F F Label sheet Open battery cover. Insert 4 "D" cell alkaline batteries (not included) as shown. Close battery cover. Turn power switch ON to play. TROUBLE-SHOOTING TIPS The playing surface is level and flat.
  • Page 3 ASSEMBLY TIPS: Look for letters or numbers marked on the tower panels (as shown) for reference. Assemble FOR EACH SIDE PANEL: the back Partially engage screws; of tower. INSIDE align each panel to Assemble the Set aside. RAIL of tower front, THEN front of tower.
  • Page 4 IMPORTANT SAFETY NOTE FOR ADULT: Tower Curve must remain attached to the top of the Tower at ALL TIMES. Push curve in until it is FULLY SEATED and SNAPS in place. Attach the shields onto tower TRACK (teeth shield CURVE on the bottom).

Table of Contents