Table of Contents
Advertisement
Troubleshooting
Problem
• Make sure both the display and 5-in-1 sensor are
placed away from any heat sources or vents
(see page 7).
Inaccurate
• Make sure both units are positioned away from
moisture sources (see page 7).
temperature or
humidity
• Make sure 5-in-1 sensor is mounted at least 1.5 m
(5 ft) off of the ground.
• Calibrate indoor and outdoor temperature and
humidity (see page 7).
• Check that the power adapter is plugged into the
display and an electrical outlet.
Display screen
• Check that the batteries are installed correctly.
not working
Batteries may need to be replaced.
• Reset the display by pressing and holding the
RESET button for 10 seconds, located in the battery
compartment of the display. Date and time will need
to be entered after a reset.
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or email
support@chaney-inst.com for assistance.
Possible Solution
12
Care & Maintenance
Display Care
Calibration
mode selected, "AUTO" or "MANUAL". Press and HOLD the "
5-7 seconds to return to AUTO mode.
NOTE:
Watch the video at www.acurite.com/5in1
" buttons
" button for
13
Advertisement
Table of Contents
