Vahle System 1 Operating Instructions Manual page 25

COMMISSIONING
Risk of injury from falling parts!
In case of improper use (faulty assembly, misuse, failure to perform maintenance,
etc.), there is a risk of parts falling down.
► Wear a helmet
► Perform regular maintenance
NOTICE!
Transport instructions
► Never hold the unit by the carbon brushes or the power cable. Always transport the
NOTICE!
The conductor rail material is susceptible to corrosion.
Corrosion can occur when working on the conductor rail with tools.
► Only tools that have not previously been used for ferritic materials may be used.
► Use own tools for the different materials (aluminum, copper, stainless steel).
► Chip-forming work (grinding etc.) must not be performed in the vicinity of the con-
NOTICE!
The following points have to be strictly observed during assembly!
► Appropriate handling of materials.
► Clean and metallic bright surfaces on all contact points.
► Firm tightening of all screws using the screw lock provided and observing the stat-
► Damaged materials must not be installed.
► Observe all applicable regulations governing installation of the plant.
WARNING!
unit holding it by the plastic base plate or by the collector plate.
ductor rail system.
ed tightening torques.
23