komodo Deluxe Double Hammock Stand Combo Quick Start Manual

2 x Base feet
4 x Plastic feet caps
1 x Base frame
2 x Hammock support frame
2 x Hammock attachment hook, curved washer & wing nut set
2 x Bolt, nut & washer set to connect Hammock support frames to base frame
2 x U bolt, nut & washer set to connect base frame to base feet
1. Choose a level location and lay out the contents of your hammock and
frame. Make sure all parts are present and place them side by side for easy
identification. Use Figure 1 as a position and component guide for the
following steps, taking particular note of the washer position in the order of
assembly.
2. Locate the four plastic feet caps and the two base feet. Slide the plastic
feet caps over the ends of the base feet, ensuring they are securely in
position.
3. Locate the base frame and the two base feet. Connect them together,
ensuring the U bolts are securely fastened into position.
4. Locate the two hammock support frames and connect them with the base
frame assembly. Ensure the bolts are securely fastened into position.
5. Position the hook into the hole towards the top of the hammock support
frame. Select the correct hole appropriate to the hammock size.
6. Position the curved washer and fasten the wing nut to the threaded bolt
end of the hook.
7. Attach the hammock to the hook as shown in Figure 2. To check the hook
is positioned into the correct hole during step 4, tension the hammock so
that when fully loaded, the hammock forms a natural curved shape with
the lowest point being a minimum of 40cm above the ground. As the
hammock itself stretches, you will need to adjust.
Figure 1
Figure 2