Contents ........................... 1 Introduction ........................2 System Overview ....................... 3 What’s In The Box ......................4 Connect the SmartBox Pro to Your Computer ............... 5 Download & Install the Allego software application .............. 6 System Requirements ......................6 Activating Allego ........................ 7 Training with Allego ......................
3. Unique, highly interactive, probe-centered user interface that allows the researcher to remain focused on the experiment at hand. This Getting Started guide is intended to provide a brief overview of the Smartbox Pro / Allego system and some of its basic functions.
Plug the AC adapter into a standard (120 V) wall outlet and connect its DC power output pin into to the power port of the unit. Connect the USB cable to the SmartBox Pro and a USB 3.0 port on your computer.
Download & Install the Allego software application Allego is the software application for interfacing with the SmartBox Pro unit. The latest version of Allego can always be found on the downloads page of the NeuroNexus website: https://neuronexus.com/products/instrumentation-data-acquisition/smartbox/allego- download/. This page is currently password protected with password: SmartboxAllego Once there, select the link for the appropriate operating system and then select “Download”...
Training with Allego To familiarize yourself with Allego before using it with a SmartBox Pro, you may download and run the SIMULATOR MODE of the software. If you do not yet have any saved recordings, you may also download and save the Allego Simulator Data File.
Page 11
1. On the left side of the interface, click Electrodes. 2. Choose a name for this tab if you desire. Suggestion: name this according to the port being used on your SmartBox Pro. 3. Choose port, headstage and probe. 4. Toggle + and – signs to enable or disable electrode sites on the probe wireframe.