Original Instructions Introduction Technical Abbreviations Key Thank you for purchasing this Triton tool. This manual contains information necessary , DC Volts Direct current for safe and effective operation of this product. This product has unique features and, even if you are familiar with similar products, it is necessary to read this manual...
Page 3
ALWAYS support large workpieces on the in-feed and out-feed sides of the router WARNING: The use of accessories or attachments not recommended by the manufacturer table, and where necessary, also to the sides. Use Triton Sliding Extension or Multi-stand may result in a risk of injury to persons.
While dust extraction can be achieved using any vacuum cleaner, domestic (bag-type) Installing and removing the router module units can fill up very quickly. For a much larger capacity, consider fitting a Triton Dust See ‘Installing and removing modules’ in the main Workcentre TWX7 manual for a complete Collector (DCA300) to your vacuum cleaner guide.
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be carried out by an authorised Triton service centre. This advice also applies to extension Using the guard cords used with this tool...
Troubleshooting Problem Possible cause Solution No power Check power supply No function when power turned on Router unit’s power switch is off Reset router power switch Levelling screws are not correctly adjusted Refer to ‘Levelling the router module’ section Table module is not level Ensure the Workcentre is situated on a secure flat surface.
Need help?
Do you have a question about the TWX7 and is the answer not in the manual?
Questions and answers