Cleaning The Water Reservoir; De-Scaling Your Brewer - Cuisinart SS-5C Series Instruction Booklet

Note: If the 6 oz (177 ml), 8 oz (236 ml) and
10 oz (295 ml) buttons are illuminated at the
same time and the power switch is in the
OFF position, your unit has overheated.
Please follow the instructions above to clean
the piercing needle and resume use.

Cleaning the Water Reservoir

It is normal over time for discoloration,
spotting or staining to appear in the water
reservoir. Results will vary depending on the
mineral content of the water used, but will
not affect the operation of the brewer.
However, be sure to clean the water
reservoir regularly to minimize buildup.
Clean inside the water reservoir with a
damp, lint-free cloth as necessary.
Maintenance
Any other servicing should be performed by
an authorized service representative.

De-Scaling Your Brewer

Mineral content in water varies from place
to place. Depending on the mineral content
of the water in your area, calcium deposits
or scale may build up in your brewer. Though
scale is non-toxic, it can hinder brewer
performance. De-scaling your brewer will
help maintain the heating element and other
parts that come in contact with water.
For optimal performance, de-scale your
brewer every 3 to 6 months. It is possible for
calcium deposits to build up faster, making it
necessary to de-scale more often. When all
the lights flash in sequence upon turning the
unit on, this indicates the need to de-scale.
Note: Before de-scaling your brewer,
remember to remove the charcoal water
filter from the water filter holder located in
the water reservoir.
To begin, you will need the following:
• 13 oz. (384 ml) of distilled white vinegar
• 26 oz. (768 ml) of water
• 16 oz. (472 ml) ceramic mug or
container (do not use paper cup)
• Access to a sink
Step 1: First Vinegar Rinse
• Fill water reservoir with 13 oz. (384 ml) of
white vinegar and 26 oz. (768 ml) of water.
• Place the ceramic mug or container on
the drip tray.
• Press and hold Power and 6 oz. (177 ml)
buttons for 2 seconds to start de-scale
function.
• Discard contents of mug into the sink.
• Repeat until ADD WATER light comes on.
• When de-scaling is complete, all LED
lights will be on.
• Discard any remaining diluted vinegar
into sink.
Step 2: Fresh Water Rinse
• Repeat Step 1 three times, using
fresh water in place of vinegar.
• This will clean the brewer plumbing and
remove any residual vinegar taste.
The brewer is now ready for normal use.
13