Download Print this page
Team Corally TOROX 60 Instruction Manual

Team Corally TOROX 60 Instruction Manual

Advertisement

Quick Links

TOROX 60
INSTRUCTION MANUAL
www.corally.com
#C-54010

Advertisement

loading

Summary of Contents for Team Corally TOROX 60

  • Page 1 TOROX 60 INSTRUCTION MANUAL www.corally.com #C-54010...
  • Page 2: Specifications

    WARNINGS - Make sure that all wires and connections are properly insulated before connecting the ESC to the motor and battery. A short circuit can cause irreparable damage to the ESC. - Make sure all devices are properly connected, a poor connection can result in loss of vehicle control or damage to the ESC.
  • Page 3 CONNECTIONS Motor Wiring There is no polarity on the A/B/C motor wires. Connect the wires to the motor and ESC. If the motor runs in reverse, reverse 2 cables to the motor. Receiver Wiring Plug the ESC cable to the Throttle Channel (TH/2) of the receiver. Plug the steering servo cable to the Steering Channel (ST/1) of the receiver.
  • Page 4 POWER ON/OFF WARNING FUNCTION 1. Power ON/OFF: Start with the ESC turned OFF ; Press the ON/OFF button to turn ON the ESC; Start with the ESC turned ON ; Press and hold the ON/OFF button to turn OFF the ESC. 2.
  • Page 5 POWER ON/OFF WARNING FUNCTION Option 3: Auto (Intermediate) Medium cutoff voltage, prone to getting the LVC Protection activated, is applicable to batteries with ordinary dis- charge capability. Option 4: Auto (High) High cutoff voltage, very prone to getting the LVC Protection activated, is applicable to packs with great discharge capability.
  • Page 6: Simplified Declaration Of Conformity

    SIMPLIFIED DECLARATION OF CONFORMITY MANUFACTURER : Team Corally hereby declares that the speedcontroller system type TOROX 60 complies with the Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following Internet address: www.corally.com...
  • Page 7: Troubleshooting

    TROUBLESHOOTING Trouble(s) Possible Causes Solution 1. Check if all ESC & battery connectors The ESC was unable to start the status LED, the 1. No power was supplied to the ESC. have been well soldered or firmly motor, and the cooling fan after it was powered 2.
  • Page 8 Team Corally • Geelseweg 80 • 2250 Olen • Belgium Tel: +32 14 25 92 94 • info@corally.com • www.corally.com...