Advertisement
WARNING! If the smell of gas is present, isolate the gas cylinder immediately and investigate the reason before re-connecting it. Be
‰
aware that propane is heavier than air and that leakage will accumulate at floor level
DO NOT use the heater if damaged. Take immediate action to repair or replace damaged parts. Use an authorised service agent
8
only.
DO NOT use the heater for residential use.
8
DO NOT allow untrained persons to ignite the heater.
8
DO NOT operate the heater without the cover.
8
DO NOT modify the heater in any way. The heater is not designed to operate in conjunction with any form of ducting.
8
DO NOT use a naked flame to try and ignite the heater.
8
DO NOT use the heater near flammable, combustible or explosive materials - liquids, solids or gases.
8
DO NOT leave the heater unattended whilst in use.
8
DO NOT obstruct the air inlet and outlet sections of the heater. Keep immediate area clean and tidy.
8
DO NOT point the heater towards the gas cylinder.
8
Keep children away from the heater.
9
Keep the heater clean and in good working order.
9
ensure that the heater is correctly turned off and the gas source isolated when not in use.
9
When not in use for any length of time, store heater in a safe, dry, childproof location.
9
▲
CARBON MONOXIDE (CO) RISKS
This heater will produce a very small amount of carbon monoxide as part of its normal operation. As carbon monoxide is a toxic gas,
particular care must be taken to provide adequate ventilation.
The result of inadequate ventilation could be fatal.
early indications of the onset of carbon monoxide poisoning include:
● Headache
● Dizziness
● Burning eyes and nasal passages
● Nausea
● Dry mouth or sore throat.
In the event of these symptoms being present, leave the area immediately and get fresh air.
Turn off the heater and take out of use until serviced.
NOTE:
This appliance is not intended for persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
2. INTRODUCTION
Perfect large heater for industrial use, ideal for heating large areas efficiently and quickly. Mounted on wheels with integral handle so easily
moved to where heating is required. Features fully automatic electronic ignition for easy trouble free starting. Fully adjustable, thermostatically
controlled heat output between 210,000Btu/hr and a maximum of 400,000Btu/hr and fuel safety cut-out in the event of overheat or power failure.
Supplied with approved propane gas regulator and hose.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .LP401
output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 61.5-117kW
output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 210,000-400,000Btu/hr
Airflow: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1400cfm
Fuel Consumption:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.2-8.4kg/hr
length: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 995mm
Width:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 405mm
Height: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 620mm
Fuel: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Propane
Heated Area: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 72,000ft³
Heated Area: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2,038mtr³
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24.6kg
Gas Pressure: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5bar
motor Power Consumption: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 145W
Supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .230V
4. ASSEMBLY
4.1.
Stand the heater carefully on end (air inlet upwards).
4.2.
Attach the chassis to the heater using six screws
(fig.1.A).
4.3.
Attach the handle to the chassis using four screws
(fig.1.B).
4.4.
Slide the axle (fig.2.A) through the chassis locations.
4.5.
Slide a spacer (fig.2.B) onto each end of the axle.
4.6.
Slide a wheel over each end of the axle, followed by a
washer (fig.2.C)
4.7.
Secure the assembly by inserting a cotter pin (fig.2.D)
in each end of the axle and bending the legs with
pliers.
5. INSTALLATION
Note:
If a small gas cylinder is used, the heater may not operate at maximum efficiency. It is recommended to use two or more cylinders
linked in parallel, to achieve maximum continuous efficiency (fig.3). If in any doubt, consult the gas supplier for advice.
© Jack Sealey limited
Fig.1
Original Language Version
Fig.2
lP401| Issue:6 (1) 09/10/18
Advertisement
