Summary of Contents for CMD RamDrive C-64
-
Page 2: Additional Installation Instructions
Often a 5/64 inch allen will serve in place of a T10 TORX driver. Additonal Clips are available from CMD for $3.00 each plus shipping. WARNING Always protect your equipment by discharging any static electricity from yourself. You maydo this by touching any grounded metal surface. - Page 3 RAMDRIVE C-64 Installation C-64 Owners Note: The C-64C model is slightly different in design and layout than the earlier C-64 computers and requires special steps during disassembly and assembly. In the procedure that follows, the additional steps required for the C64-C are enclosed within a box.
- Page 4 Step 9. Some 64s have a cardboard/foil or metal shield covering most of the circuit board components. If your computer has one of these shields, remove it at this time. The shield is held in by self-taping screws. Step 10. For 6.5 inches wide circuit boards (C64 and C64-C): Locate resister R44 in one of the two areas shown.
- Page 5 Step 11 Carefully feed the other end of the clip assembly (the end wit the xmaller connector on it) through the opening in the upper right corner of the shield located over the Cartidge Port. If you wish, you may secue the clip assembly wire near the clip with a piece of electrical Tape, by taping in to the circuit board a few inches away from the clip.
- Page 6 RamDrive C-128 Installation Step 1. Make sure that the C-128 power switch is OFF and any peripherals attached to the C-128 are also switched OFF. Unplug the C-128 AC power cord from it’s outlet. Step 2. Step 3. Unplug ALL cables from the C-128. Step 4.
- Page 7 RAMDRIVE SX-64 Installation Step 1. Make sure the SX-64 power switch is OFF. Also make sure that any peripherals (disk drives, Printer, etc) are attached to the SX-64 are also switched OFF. Step 2. Unplug the SX-64 power supply cord from its AC outlet. Step 3.
- Page 8 RAMDRIVE C-128D Installation Step 1. Make sure the C-128D is switched OFF and that any peripherals attached to the C-128D are also switched OFF. Step 2 Unplug the C-128D AC power cord from the outlet. Step 3. Unplug all cables from the C-128D and remove any devices plugged into the Cartridge and User ports.
- Page 9 RAMDRIVE Clip Connector Installation Procedure: Step 1. Locate the connector end of the Clip assembly, which should be near the rear of your computer On the end of the wire coming out of the Cartridge Port opening. Hold the connector with the two tabs pointing down, and the open end pointing away from the rear of your computer.
Need help?
Do you have a question about the RamDrive C-64 and is the answer not in the manual?
Questions and answers