Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sound Sculpture PowerSwap
Summary of Contents for Sound Sculpture PowerSwap
- Page 1 PowerSwap 1000 Watt Musical Instrument Speaker Swapper...
- Page 2 Sound Sculpture shall not be liable for any consequential damage or loss of profits as a result of the use of this product even if Sound Sculpture is advised of the possibility of such damages or loss. In no event will Sound Sculpture's liability exceed the price paid for the product.
- Page 3 This publication may not be reproduced by any means in whole or in part in any form or by any means including electronic except for personal use without written consent from an officer of Sound Sculpture Musical Instrument Products.
- Page 4 INTRODUCTION ....................................4 PANEL FEATURES ....................................4 SETTING THE POWERSWAP MIDI CHANNEL .............................4 CONNECTING THE POWERSWAP TO THE AMP AND SPEAKERS ......................5 CONNECTING MIDI TO THE POWERSWAP ............................5 CONNECTING A MECHANICAL FOOTSWITCH TO THE POWERSWAP ....................5 CONNECTING POWER TO THE POWERSWAP ............................6...
- Page 5 Setting the PowerSwap MIDI Channel The PowerSwap is factory set to MIDI channel 16. If this is an acceptable MIDI channel for your use than you do not need to do anything more. If you wish to set the unit to respond to another MIDI channel, then you will need to change the switch setting inside the unit.
- Page 6 Connect a standard MIDI cable between your MIDI foot controller MIDI OUT jack and the PowerSwap MIDI IN jack. Connect an additional cable between the MIDI THRU jack on the PowerSwap and the MIDI IN jack of the next MIDI device in your chain as you normally would.
- Page 7 Connecting Power to the PowerSwap Attach the supplied modular power supply to the power input on the PowerSwap. If you will be using a power substitute then it should supply 9V DC at 100ma using a 2.1mm connector with center pin positive. You can operate the unit safely with up to 12V DC supplies without damage.
- Page 8 PowerSwap. You can have a single switch toggle the unit or separate switches to go to either an on or off state. If your foot pedal has additional switches that send out two value Controller commands, sometimes referred to as “Instant Access” switches, you may use one of these switches as well to control the PowerSwap.
Need help?
Do you have a question about the PowerSwap and is the answer not in the manual?
Questions and answers