Table of Contents
Advertisement
ENGLISH
8
B Motor unit
-
9 Locking clamp
-
10 On/off button with power-on light
-
11 Reverse/Pre-clean button
-
12 Power cord
-
13 Cord storage wrap
-
14 Pulp container
-
15 Safety pins
C Jug (HR1897/HR1895 only)
-
16 Juice jug
-
17 Lid of juice jug
Not shown: grey two-part filter for fiber juice (HR1897 only)
Before first use
Thoroughly clean all parts before you use the appliance for the first time (see chapter 'Cleaning').
Note: Make sure all parts are completely dry before you start using the appliance.
Preparing for use
Assembling the juicing unit
Always unwind the power cord completely before you switch on the appliance.
1
Remove all packing material or labels before using.
2
Attach the pulp outlet to the juicing unit and turn it clockwise until the arrow ( Á) points to
the 'locked' indication. (Fig. 2)
3
Insert the juicing screw into the juicing unit (Fig. 3).
4
Assemble the two parts of the filter (Fig. 4).
5
Place the two-part filter over the juicing screw (Fig. 5).
Tip: Use the black two-part filter for clear juice. If you prefer cloudy juice with more fiber in it, use the
grey two-part filter.
6
Attach the spout to the juicing unit and turn it clockwise until the arrow ( Á) points to the
'locked' indication. (Fig. 6)
7
Place the berry tray on the feeding tube (Fig. 7).
Placing the juicing unit onto the motor unit
1
Place the assembled juicing unit onto the motor unit, with the pulp outlet fitting into the
opening on the motor unit (Fig. 8).
2
Align the projections on the juicing unit with the recesses in the motor unit. Slide the juicing
unit onto the motor unit until it locks into place. (Fig. 9)
3
Press the juicing unit onto the motor unit (1) and then close the locking clamp (2). (Fig. 10)
Note: If the locking clamp cannot be closed, check if the juicing unit is positioned properly with the
projections on the juicing unit into the recesses of the motor unit.
4
Slide the pulp container into the motor unit (Fig. 11).
Advertisement
Table of Contents
