Subscribe to Our Youtube Channel
Related Manuals for H&K MF03
Summary of Contents for H&K MF03
- Page 1 H&K DALLAS INC. “Our Quality Shines Through” PORTABLE MEAT FREEZER MF03 H&K DALLAS INC., 1343 S.HENDERSON AVE., DALLAS, TX 75223.
-
Page 2: Table Of Contents
TABLE OF CONTENTS WARNINGS ................INTRODUCTION ..............WARRANTY STATEMENT ..........SERVICE INFORMATION ............ POWER REQUIREMENTS ........... INSTALLATION ..............OPERATING PROCEDURE ..........MAINTENANCE ..............TROUBLESHOOTING ............UNIT PRINT ................ELECTRICAL SCHEMATIC ..........CONDENSING UNIT SPECIFICATIONS ......OPTIONS .................. REPLACEMENT PARTS ............240V/50HZ SCHEMATIC ............ -
Page 3: Warnings
WARNINGS!!! DO NOT OPERATE OR SERVICE THE FREEZER WITHOUT FIRST READING THIS MANUAL. DISCONNECT ALL POWER SOURCES BEFORE ATTEMPT- ING ANY SERVICE OR REPAIR WORK. DO NOT ADJUST THE DIFFERENTIAL SCREW ON THE THERMOSTAT. A LICENSED TECHNICIAN SHOULD DO ALL SERVICING AND REPAIR. -
Page 4: Introduction
INTRODUCTION The MF03 meat freezer is designed to hold all boxes of patties that are kept frozen, at the desired temperature during normal and peak sales periods. WARRANTY STATEMENT H&K makes the following limited warranties to the original purchaser only for this equip- ment and replacement parts: H&K warrants all components to be free of defects in material and workmanship, if properly... -
Page 5: Service Information
H&K shall not be liable for loss, damages or expenses arising from misuse, abuse, altera- tion, accident or improper installation of the Freezer such as: ? Improper or unauthorized repair; ? Failure to follow proper installation instruction; ? Improper maintenance; ? Damage in shipment;... -
Page 6: Installation
INSTALLATION 1. Inspection: Upon receipt, examine the equipment carefully for any damage. If damage has occurred, notify the carrier and H&K immediately.. 2. Unpacking: Remove the unit from the plastic wrap and untie the electrical cord by re- moving the holding tape. It is recommended that the unit remain crated until it has reached the installation location. -
Page 7: Maintenance
Wait for 1 hour before readjusting the thermostat. Excessive tampering with the thermo- stat may lead to service difficulties. 5. Condensate Disposal: The condensate from the freezer is disposed via a drain at the bot- tom of the freezer. CAUTION: Do not leave the freezer cover open for extended period of time. MAINTENANCE 1. -
Page 8: Troubleshooting
TROUBLESHOOTING PROBLEM CAUSE SOLUTION Compressor will not start 1. Cord set not plugged in. 1. Plug in cord. 2. Thermostat stuck in open 2. Replace thermostat. position. 3. Check wiring against dia- 3. Improperly wired. gram. 4. Low voltage to unit. 4. -
Page 9: Unit Print
H&K DALLAS INC., 1343 S.HENDERSON AVE., DALLAS, TX 75223. -
Page 10: Electrical Schematic
H&K DALLAS INC., 1343 S.HENDERSON AVE., DALLAS, TX 75223. -
Page 11: Condensing Unit Specifications
COMPRESSOR INLET CONDENSER OUTLET CONDENSING UNIT SPECIFICATIONS REFRIGERANT R-404A CAPACITY @ 90°F AMBIENT 1590 Btuh@-20°F (0.46 kW@-28.8°C) HORSE POWER OVERALL DIMENSIONS (INCHES) 15.4 X 11.3 X 9.9 OPERATING PRESSURES LSP = 12 PSIG HSP = 240 PSIG ELECTRICAL DATA 120-1-60 MCA 9.1 MAX. -
Page 12: Options
OPTIONS DESCRIPTION H&K PART NO. SELF CLOSING COVER ASSEMBLY 450826 FRAME ASSEMBLY SELF CLOSING COVER 450826.01A SLIDE COVER 450826.02A REMOVABLE REAR TOP 450826.03A WIRE SHELF PCCAW282 FIXED GLOVE DISPENSER 66051 ADJUSTABLE GLOVE DISPENSER 65537 REPLACEMENT PARTS DESCRIPTION H&K PART NO. CONDENSING UNIT P-1-207 CAP TUBE... -
Page 13: 240V/50Hz Schematic
H&K DALLAS INC., 1343 S.HENDERSON AVE., DALLAS, TX 75223.
Need help?
Do you have a question about the MF03 and is the answer not in the manual?
Questions and answers