Table of Contents
Advertisement
SET POWER LEVEL
Range: 1 to 5
With the STATUS LED solid red, press and hold the PROG button until the
STATUS LED turns off.
number of times equal to the current power setting.
default power level is 5, so the STATUS LED will flash green five times.
After the flashing stops you have five seconds to change the power level. To
change the power level, press and release the PROG button one time for
each level of power you would like. For example, if you wanted the power
level to be the lowest possible value, you would press and release the PROG
button just once. If you wanted the power level to be 3, you would press
and release the button three times.
If you do not press the PROG button within five seconds, or if the value you
enter exceeds what is allowed, the STATUS LED will alternately flash red and
green (error condition occurred) and no change will be made. At this point,
you are back at the programming mode start (where you can select a
programming option).
If you do make a change, the STATUS LED will blink green/red/orange in
rapid succession to let you know that the change was successful.
Below is a table of required power levels for various countries.
Country
North America
Australia & U.K.
Japan & France
Europe
The STATUS LED will now slowly flash green the
1-5
1-5
1-2 Hop Mode 1, otherwise 1-5
1-2 Hop Mode 1, otherwise 1-5
12
For example, the
Allowable setting
Advertisement
Table of Contents
