Toro 132-1300 Installation Instructions page 2

Installing the Fuel Sender
1. Position the machine on a level surface, raise the cutting
unit, engage the parking break, ensure that the traction
pedal is in the Neutral position and the PTO lever is
in the O position, stop the engine and remove the
FF
key from the switch.
2. Remove existing set of 5 screws and 5 washers from
the tank assembly.
3. Using the set of 5 screws and 5 washers from the tank
assembly, install the fuel sender adapter onto the fuel
tank (Figure 1).
Note: Place the fuel sender adapter onto the fuel tank
using the orientation indicators to align it properly
(Figure 2).
1
2
3
1. Screw
2. Washer
2
1
g029204
1. Orientation indicators
4
g029203 g029203
Figure 1
3. Fuel-sender adapter
4. Gasket
Figure 2
2. Fuel sender adapter
4. Install the float gauge onto the fuel tank
4
1. Wiring harness
2. Screw (5)
3. Washer (5)
5. Route the wiring harness along the groves in the fuel
tank, under the frame, and to the connector near the
oil filter (Figure
1
1. Wiring harness
2. Wiring harness (routed
under the frame)
2
(Figure
1
2
3
g029213
Figure 3
4. Float gauge
5. Gasket
6. Fuel sender adapter
4).
3
2
g029304
Figure 4
3. Plug
3).