System Configurations - Diamond MICROV2 Series Owner's Manual

Table of Contents

Advertisement

SYSTEM CONFIGURATIONS

4.TURN-ON OPTIONS - configure the "Turn-On Mode" switch for desired turn-on trigger. There are 3 modes available on the
Bomber series amplifier, REM, DC and VOX. REM is the standard 12V trigger wire, DC or DC offset, when connected
high level in, will sense differences in ground in your wiring through the speaker leads and turn on amplifier, VOX (signal
sensing) will sense any kind of signal input into the amplifier RCA turning on the amplifier. Select VOX when using any
DIAMOND AUDIO Bluetooth Controller. The most preferred and reliable method is using the REM setting with a 12V
trigger wire connected to the vehicles ignition and will provide instant on and off for the amplifier. VOX and DC will provide
turn on capabilities for the amplifier when a 12V trigger wire is not available. These methods will have some delay in
turning the amplifier on and off.
5. BTR Port – (Bluetooth Receiver Port) This port is specifically to be used with any DIAMOND AUDIO Bluetooth controller.
This will allow direct plug in to the amplifier and control simple functions of music playback through the BTR receiver. The
supplied cable is the ONLY cable that can be used to plug into the BTR port on the amplifier. Connecting any other
non-approved cable into the BTR port of the amplifier can cause damage to the amplifier and not be covered under
warranty. The BTR will pair to your phone or selected BT device and will allow playback through the amplifier to speakers
giving you unlimited install options. Play, Pause, Volume up/down, track up/down, Pairing and power on/off of BT
audio through this one solution. Once paired, the BTR will auto pair the last person paired to the controller when it was
powered down. The unit will remember up to 9 users and have memory without battery for up to 30 days.
REMEMBER: When connecting a DIAMOND AUDIO controller using the BTR port select the turn on option to VOX.
DASH
REAR MOUNT
NUT
NOTE: MAKE SURE TO SET
REMOTE IN (YELLOW)
AUX IN
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micro1v2Micro2v2Micro4v2Micro5v2

Table of Contents