Advertisement
Quick Links
--
lliti
Magnetic Lock Wiring Instructions
fatt Ac.e ..11 Security Corp.
A.12VDC Input:
Required power 0.5 amp (Maximum).
Connect the ground( -) lead from a 12VDC power source to terminal 2.
Connect the positive( +) lead from a 12VDC power source to terminal 1.
Checkjumperfor 12VDC operation.
B.24VDC input:
Require power 0.25 amp (Maximum).
Connect the ground(-) lead from a 24VDC power source in terminal2.
Connect the positive(+) lead from a 24VDC power source to terrninal1.
Check jumper for 24VDC operation.
C.Contacts:
Reed switch dry contacts are rated max 3W(max switching contact 0.2SA) at 30VDC/AC for safe
operation. Do not exceed this rating.
If you require a normally open switch,connect the wires from the system to terminal4 and terminal 3.
If you require a normally closed switch,connect the wires from the system to terminal4 and terminalS.
Important!
1. The product should only be powered by a LlL listed power supply.
2. If power switch is not wired between DC source voltage and magnet .it will take a longer time to
de-energize the magnet simulating residual magnetism.(see below)
/~~,
~~
/
::,,, c-.
-..J",
s:
-~-
~=
,
,
,
OR
24V
-----------------------
Correct
Incorrect
Printed Circuit Board Schematic
o~
0
-G
0 " - - - -
Mag Bond Sensor
Timer 0- 90 sec
ED
0
S2
~
I
~
I
C]IO:e.;-~
III------------
L
.
.
pOwJe~mSpe~~ctor
o
-
0
1881
----------------------- [j]]
~
~
~
c
~ ~~~ ~~~
2"
,
m
,
,
POWER SUPPLY
=====----.J
,
Magnet
Dry Contact
WG001-F
Advertisement
