Advertisement
Installation instructions
System drawer 60-144
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
These installation instructions apply to the model: 620
General notes
If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be
strictly observed.
Identification plate
A
Remove the drawer. The identification plate is located on the inside of the appliance.
Installation
The drawer must be secured by 4 screws to prevent tipping.
1. Fix a bracket set 60 W (not included in the scope of delivery) for an
appliance located above or below.
2. Carefully slide appliance into the niche until it is flush with the front
of the cabinet.
3. Open the drawer and fix in place from the front, using the 4 supplied
screws S.
1
J620.113-0
12.8.09 ITH
W
S
Advertisement
Table of Contents
Summary of Contents for V-ZUG System drawer 60-144
- Page 1 Installation instructions J620.113-0 System drawer 60-144 12.8.09 ITH The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order specified. Validity These installation instructions apply to the model: 620...
- Page 2 Installation instructions J620.113-0 System drawer 60-144 12.8.09 ITH Built-in solo Installation combinations If a second appliance is installed in the same niche (above or below), you should use bracket set 60 W to support the upper appliance. Below a oven...
Need help?
Do you have a question about the System drawer 60-144 and is the answer not in the manual?
Questions and answers