Hides HV-110 Manual

HiDes Receiver HV-110/HV-120/HV-122
Here are some set up and usage tips for the HIDes DVB-T receivers for use with
the W0ATN repeater and is provided to supplement each receiver's Quick Start
Guide (QSG) document.
For a new receiver or firmware update, perform the initial Setup in the
following order:
Rear panel Bandwidth (BW) selection switch must be in the Down (2-4) position
before applying DC power.
To quickly switch between 426.000 and 440.000, a microSD card is required to
store these two frequencies in the file "CustomChannelTable.txt."
may be found on the DVD provided with the receiver.
has commercial TV channel frequencies).
change the frequency of the first two channels to 426000 and 440000 with 4MHz
BW using your text editor. The file should be put in the root directory of the
microSD card. While your here, make a new directory in the root and name it
RECORD. This is where any recordings (using the RED button on the OSD
controller) will be stored.
Defined Channel and answer Yes to the process question.
frequencies will be "scanned" with an on-the-air signal and then added in the
Channel Manager.
If a microSD card is not handy (use any size card up to 32MB) or do not want to
do the above, then start with Step 1 and skip over Step 2.
1 -

Main Menu - Settings

Display Preference
Display Mode
PAT Mismatched
Keep Last Video
Warning Message
(use "Factory Defaults" for all others)
2 -

Main Menu - Installation

installed in the receiver first)
Country
Defined List
After selecting User Defined, push the RED button, answer yes and the scan will
begin. Repeat this for the 2nd frequency but answer No (see next Note).
Next, go to the Tools menu and select User
1080P60 or 1080PI60
Disable
OFF
OFF
(microSD card edit as described above must be
User Defined
(www.hides.com.tw)
File requires editing (it
Keep the format the same and just
Quick Start Guide, refer to User
This file
Later, these two