Summary of Contents for WatchGas ATEX BEACON
- Page 1 D e t e c t i o n Manual Atex Beacon 78 Ultra bright RGB LEDs - Colour selectable patterns - Partnr: ATEX-BEACON...
-
Page 2: Table Of Contents
Content D e t e c t i o n Warnings and avertiseement Disposal About the ATEX Beacon PCB layout Installation Analogue controlled Modbus controlled Settings Supported codes Register map Pin numbers Light effect types Specifications Troubleshooting Modbus Table... -
Page 3: Warnings And Avertiseement
ATEX Beacon. Ensure you read this user manual fully before installing and operating the ATEX Beacon. If you are installing this ATEX Beacon for use by others, you must leave this manual with the end user. Installation must be carried out, in accordance with latest codes and regulations, by a qualified electrician. -
Page 4: Pcb Layout
ATEX Beacon D e t e c t i o n ATEX Beacon PCB layout Power supply: 9-30V DC (min 9W) Stand-by current: <0.1W Trigger voltage positive: 6-30V DC Trigger voltage ground: min 6V DC below supply Trigger current: max 6mA Cable diameter: 0.25mm2 to 3.0 mm2 (12 to 24AWG) -
Page 5: Installation
To open the Housing please first remove the hexagon m3 bolt, then unscrew the glass top of the housing. To wire the ATEX Beacon remove LED insert by removing the 3 Nylon screws, and disconnect the LED PCB from connector J3. -
Page 6: Modbus Controlled
ATEX Beacon D e t e c t i o n MODBUS CONTROLLED Settings The following configuration options are available with the dip switches Option Default value Valid range Description DIP switch Modbus ID 0 (disabled) 1-255 Select Modbus 5/12... -
Page 7: Register Map
ATEX Beacon D e t e c t i o n REGISTER MAP Data can be read using the Read Holding Registers command. A memory map de- tailing all useful locations is listed below: Address Content Unit 0x0000 Light effect type View note [1];... -
Page 8: Specifications
ATEX Beacon D e t e c t i o n Specifications Size 20,5 x 13,6 cm (7.87 x 5.11 in.) Weight 1675grams (3.69lbs.) Operating Temperature -20 to +40°C (-4 to 104°F) IP Rating IP 65 Cable entry 2 x ¾”NPT Material Copper free aluminium LM6 (copper<0.05%) -
Page 9: Modbus Table
ATEX Beacon D e t e c t i o n Modbus Table Dip Switch Dip Switch Dip Switch Dip Switch adress adress adress adress...