magic lite RGB Neon Flex NFLX RGB Series Installation And Safety Instruction

INSTALLATION GUIDE

For installations with multiple lengths of RGB Neon Flex, you
will need an additional signal amplifier and class 2, 24V DC
non-dimmable power supply for each additional run, as follows:
A. Linear Installation Layout
B. Multiple Run Layout
1. Connect wires from output of controller to input side of
signal amplifier. If continuing in a straight line, you may simply
connect from the end of previous piece of RGB Neon Flex to
the input side of the signal amplifier by using an opposite power
feed (part# NFLX-RGB-CONKIT-6FT-O). If running wires wires
from the output of the controller, in multiple parallel runs, we
recommend using wires of at least 18AWG.
2. Connect next length of RGB Neon Flex to the output side of
signal amplifier.
NOTE: Black wire on power feed connectors goes to (+) on
both input and output of the signal amplifier.
3. Connect the low voltage side of the class 2 power supply to the
+/- contacts of the signal amplifier.
4. Connect line voltage side of the power supply to line voltage.

ACCESSORIES

NFLX-RGB-CONTROL NFLX-RGB-AMP
(RGB controller) (RGB signal amplifier)
NFLX-RGB-JUMP
NFLX-RGB-CONKIT-6FT-O
(RGB power feed con- (RGB Jumper
nector, 6FT, opposite) connector 15cm [6in])
NFLX-ENDS NFLX-CLIPS
(End cap) (Mounting clips)
NFLX-CHANNEL
(Aluminum mounting channel 1M [3.28FT])

NON-DIMMABLE POWER SUPPLIES

• MLDR-120-24
• Indoor/Outdoor
• Max recommended load:
90W per single tap,
120W combined two secondary taps
• 120W hardwire
• Input: 100-240V AC
• Output: 24V DC
• 10" x 3 3/8" x 3 3/16" (254 x 85.7 x 80.9mm)
NFLX-RGB-CONKIT-6FT
(RGB power feed connector,
RGB LED
6FT)
Neon Flex
NFLX-RGB-PINS
(RGB pins)

Applications:

• Building outlines
• Stairway and aisle lighting
• Signs
• Decks
• Pathway Lighting
• Billboards
• Highlighting architectural features
NFLX-XX-RGB
www.magiclite.com