Table of Contents
Advertisement
Operating htructions
Starting your washer
Be sure to measure and add detergent, then place a sorted bad in the washer
1. Select a load aloe
l
Position the Load Size Selector al the
setting that describes the size of bad
you want to wash.
l
The selector can be set anywhere on
or between EX SMALL (a few small
items) and EX LARGE (a full bad).
l
To change the water level after the
washer has started to fill, slide the
selector to RESET, then to the
desired water level.
NOTE: For best washing results, items
should move freely in the washer. Do
not overload the washer or choose a
water level that is too bw for your wash
bad.
For best results with permanent
press cbthes, use the EX LARGE
water level.
Reduce wash time when using EX
SMALL water level setting. Loads with
only a few small items need less wash
time for best results.
2. Select water temperature
l
Match the water temperature to the
type of fabric and soils being washed.
l
The top temperature is the wash
selection and the bottom temperature
is the rinse selection.
l
An indicator shows which temperature
has been selected.
NOTE: Use warm wash water with the
PERMANENT PRESS or KNITS
GENTLE cycles.
For heavily soiled permanent press
or knit clothes, prewash or pre-soak
before washing in warm water.
ALWAYS use cold rinse water for
permanent press fabrics.
Advertisement
Table of Contents
