Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1.
Loosely attach (1) lock handle to hold-down
clamp assembly (see Figure 8).
Hold-Down
Clamp Assembly
Lock
Handle
Figure 8. Lock handle attached to hold-down
clamp assembly.
2.
Attach hold-down post to table with 12mm flat
washer, 12mm lock washer, and M12-1.75
hex nut (see Figure 9).
Figure 9. Mounting hold-down post to table.
Model G0846 (Mfd. Since 02/18)
3.
Slide hold-down clamp assembly over hold-
down post using either mounting hole for now
(see Figure 10). Tighten lock handle.
Mounting
Holes
Lock
Handle
Hold-Down
Post
Figure 10. Placement of hold-down clamp
assembly.
4.
Place collar inside end of indexing guide with
flat side facing out, then secure to stud with
8mm fender washer, standoff hex nut, lock
handle, compression spring, and shoulder
screw (see Figure 11).
Standoff
Hex Nut
Lock
Handle
Figure 11. Installing components on indexing
guide shaft.
Indexing
Guide
Collar
-17-
Advertisement
Table of Contents
