SUPPLEMENT READ THIS MANUAL CAREFULLY! It contains important safety information. TABLE OF CONTENTS TABLE OF CONTENTS EASY RIDER CABLE ROUTING....2 Shifter Choice and Positioning SOME RECUMBENT-SPECIFIC RIDING Mid-Drive / Mid-Drive Bearing CHARACTERISTICS....4-7 Front Chain Tensioner SET UP AND ADJUSTMENT....8-10 Chainring Bolts...
(29cm) long! please contact Cannondale. Rear Brake Rear Your Easy Rider should have included both a standard owner’s manual and this Cable Derailleur supplement. If you did not receive both of these documents, please download Cable and print one from the Cannondale website Tech Center or call our customer service line at 1-800-BIKE-USA in the U.S.
–slower than walking – (See section 4 F of the Cannondale Owners Manual and the instructions from and that you heel is down and your toe is up. If you are going too fast, or try to the manufacturer of your clipless pedal system).
Page 4
We have Off-road riding: These are not mountain bikes. The Easy Rider is similar to a included a rear view mirror as original equipment. Adjusted for the rider and conventional hybrid in terms of off-road capability.
Your Cannondale dealer should have correctly performed all adjustments before handlebars and to have your the sale of the bicycle. If you feel that your Easy Rider is out of adjustment, Fig. 8 Fig. 8 hands slightly lower than please take the bike to your Authorized Cannondale Retailer.
The Easy Rider fork includes the MC60 cartridge that offers 60mm of travel using the Advanced Spring System’s coil spring / MCU combination. The Use only brakes designed to be mounted to existing cartridge also features a mechanical air damper that controls the compression cantilever bosses.
Page 8
—————————————————————————————————---—— The rear suspension uses a coil- * * * * Use blue spring (available from your Cannondale retailer) in fork or go to over shock, meaning that a steel large size bike providing you are over 5’ 7’’ (170cm)
Clean the area inside the boot of any dirt and old grease. Inspect Easy Rider to your Cannondale retailer for a fork tune up every 6 months or 60 the inner races and the steerer tube for corrosion, cracks, or a bent steerer hours of riding.
BMX market. We believe that they are ideal for the Easy Rider. They are very tough, minimizing the risk of flats. They have high air pressure capability, necessary for use on the rear, which will carry approximately 70% of the weight.
Cannondale tandems. the primary drive chain (which turns the fourth chainring in). Your Easy Rider will be delivered with this mechanism properly adjusted. If you think that the front chain seems to have excessive slack, let your retailer take a Brake set up: Please see enclosed brake manufacturers instructions.
Fenders: Front: Look for 16” front fenders, Bike E fenders work fine. Rear: A radius on each plastic small “shorty” fender used on some mountain bikes fits the Easy Rider and is slide lines up with the radius on each side of the seat rail. See Fig. 15. See available from Cannondale, part # KF032/.
CANNONDALE WARRANTY Your Cannondale East Rider frame is warrantied against manufacturing defects in materials and/or workmanship for the lifetime of the original owner. Under this warranty we will repair any defective frame or, at our discretion, we will replace a defective frame with the same or comparable model (due to product evolution).