Advertisement
K-].05
ASSEMBLY TNSTRUCTTONS
Operator stands on side A1 of table.
Opposite side is side
A2.
1.
Clamp
two supports
A1. (10960A)
and A2 (109608) to table
opposite each other.
Instafl
nylon tape (10964).
Pass one end
of tape through
top roller
(10862) of track base Al (10961A) and under tape
clamp
on support.
Tighten tape c1amp. Pull- tape across tabte, over
top roller
on track
base
A2 (10961A), around lower rolfer
(IOg72)
and
up to tape cIamp. Tighten tape
clamp.
Attach cutter track
(10966A)
to A1
base
with bolts (10857), flat-
washers
(10932)
, and lockwashers
(1093f)
. Attach cutter track to
A2 base with bracket (10859). Bracket sl_ides over track and
base.
It is then
l-ocked
from underneath
base A2
with (2) bolts
(10860).
Switch release
(10968A)
should be at A2 end. To operate ply
counter install
trip wire spring onto cutter track.*
Remove
from cutter track (2) phillips
pan head screws
(10907C)
at A1 side.
Remove
shock absorber clamp (10985c) and
shock
absorber (109858). rnsert standard of cutter into groove in
track with
machine
handle facing A1 side.
Replace shock absorber,
shock absorber clamp and
screws.
3.
4.
7.
B.
Clamp
two supports
81
(10960C)
each
other.
81 support
should
and
82
(10960D)
to
tabl_e opposite
be on
same
side
as
Al_.
rnstal-l nylon tape (10964). pass one end of tape throuqh top
roller
(l-0972) of track base Bl (10962A) and under tape clarnf
on
support.
Tighten tape clamp. pull tape across table, over top
roll-er on track base 82 (10962A), around lower rol]er
(rogj2)
and
up to tape clamp. Tighten tape
clamp,
rnsert end rail mounting T-bolts (1086r) into channels of
encl
rail
(10969A)
. Fasten end rail with mounting T-bo]ts in
channels
thru lifting
handle onto end rail
base with nuts (10930), ft.rt-
washers (10932) and lockwashers (10931). Repeat for other side.
Both sides of cutter track
and end
rail
should raise equally.
Adjust tension on tape if
necessary.
Cutter
may
be mounted in
"PUSH"
position if desired.
Machine is
off at side Al and operator
pushes machine
handle to start
moLor
and cut.
To install
in this position,
mount
track
(10966A)
with
switch release at A1
end.
Advertisement
