Omnitracs XRS XR-980 Installation

2013 & newer mack

Advertisement

Relay Installation – 2013 & Newer Mack
January 2016

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XRS XR-980 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Omnitracs XRS XR-980

  • Page 1 Relay Installation – 2013 & Newer Mack January 2016...
  • Page 2 Copyright © XRS Corporation. All Rights Reserved. This content is for informational or instructional purposes only. This content may be changed or superseded without notice, and is not part of any XRS product or services warranty. ©XRS Corporation Omnitracs XRS Relay Installation January 2016: XR-9802 Rev E Page 2...
  • Page 3 Use this guide to connect a Relay to a 2013 and newer Mack truck with cable CB -0174-02. NOTE: The supplied cable may have either a red or orange cable color, and may appear differently than the image. ©XRS Corporation Omnitracs XRS Relay Installation January 2016: XR-9802 Rev E Page 3...
  • Page 4 Be sure there is a 2 Amp or greater fuse present in the Fuse 11 location. Consult your re t vehicle fuse chart for the location of the Battery Fuse 11 location. 2. Connect black (ground) wire to a post labeled “GROUND.” ©XRS Corporation Omnitracs XRS Relay Installation January 2016: XR-9802 Rev E Page 4...
  • Page 5 4. Run the 15-pin end of the cable through the fuse panel cover and connect to the Relay. 5. Replace the fuse panel cover. The installation is complete. Plastic Locking Clip ©XRS Corporation Omnitracs XRS Relay Installation January 2016: XR-9802 Rev E Page 5...

Table of Contents