Turbosmart SUPRA JZA80 TWIN Instructions Manual

SUPRA JZA80 TWIN TURBO BLOW-OFF VALVE ADAPTOR INSTRUCTIONS

IMPORTANT NOTES ON FITTING YOUR SUPRA TWIN TURBO ADAPTOR

Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.

ADAPTOR KIT CONTENTS

Please check that the following items have been supplied in your Supra Twin Turbo Adaptor Kit.
Quantity
1 Supra TT adaptor pipe
2 90mm constant tension hose clamps
1 70mm constant tension hose clamps
1 75mm ID Silicon hose coupler
1 Pre-assembled Silicon hose assembly
1 5mm spring clamp
1 6mm spring clamp
2 19mm blanking plug
1 250mm long cable tie
2 150mm long cable tie
Note:
The Supra TT pipework adaptor kit readily accepts the following Turbosmart BOVs:
To install a Dual Port or Plumb Back BOV, fabrication will be required to connect the plumb-back fitting to the intake.

FITTING YOUR SUPRA TWIN TURBO BOV ADAPTOR

Note: Please thoroughly read and understand both these instructions and the fitting instructions supplied with your
BOV before commencing this installation.
Step 1. Locate the factory BOV and factory intercooler
outlet pipe.
Factory Intercooler Inlet Pipe
Factory Intercooler Outlet Pipe
Description
Joining pipe from the intercooler to the throttle body
Secures the adaptor pipe to the throttle body
Secures the adaptor pipe to the intercooler pipe
To connect the adaptor pipe to the throttle body
Connects the vacuum/boost source to the Turbosmart BOV
Secures the 5mm Silicon hose to the Turbosmart BOV
Secures the 6mm Silicon hose to the factory vacuum/boost source
To block off the factory boost pipe and return pipe
To support the radiator hose by securing it to the BOV
To support the vacuum/boost hose by securing it to radiator hose
Blow Off Valve Name
Blow-off Valve - Vee Port
Blow-off Valve - Supersonic
Blow-off Valve - Megasonic
Factory BOV
Turbosmart Pty Limited P.O.Box 264 Croydon, NSW, 2132 Australia ABN: 69 081 069 794
Ph: +(612) 9798 2866 Fx: +(612) 9798 2826 Email: instructions@turbosmart.com.au
Use
Step 2. The intercooler inlet pipe needs to be removed
to access the factory BOV. Loosen the two hose
clamps securing the intercooler inlet pipe with a Philips
head screwdriver or 10mm socket.
PART
NUMBER
FG-ADM-
SUPRA
Part No.
FG-BOV-002VP
FG-BOV-003SS
FG-BOV-003MS