Installation - Garden Lights 6269011 Manual

[Afbeelding E]
4. The Plus Switch is fitted with a light sensor and can be configured in the Garden Lights app to switch
on or off, depending on whether light or darkness is detected. If you want to use this function, take the
position of the sensor into account when placing the Plus Switch. Make sure the sensor is exposed to
ambient light. Prevent stray light from other light sources (e.g. street lamps) from reaching the sensor as
this may interfere with the sensor's correct operation.
[Afbeelding F]
5. A reset button is located on the back of the Plus Switch that can be used to reset the Plus Switch to its
factory settings. Use this button in the event of malfunction or if you forgot your password (configured
through the app). Take the following steps to reset the Plus Switch to its factory settings:
1. Make sure the Plus Switch is powered on, indicated by the green indicator light on the NXT Switch.
2. Press and hold the reset button for at least six seconds
9. After releasing the button, wait a few seconds
4. The green indicator light will flash twice before lighting up permanently. The Plus Switch has now
been reset to its factory settings.
5. If your Plus Switch has already been connected through the app: Delete the Plus Switch from your
network. To do so, go to the menu Extra -> Modify Product
6. (Re)connect the Plus Switch to your network. To do so, open the app and go to the menu Extra ->
Add product. Or choose New network in the start screen of the app.

INSTALLATION

[Figure G]
1. Screw the antenna onto the Switch
Option 1: Wall mounting
[Figure H]
1. Fix the wall bracket to the wall with the supplied screws.
[Figure I]
2. Place the Switch in the wall bracket.
Option 2: Ground placement
[Figure J]
1. Push the Spike into the ground up to the marking.
[Figure K]
2. Place the Switch on the Spike.
GL Manual SWITCH 2020.indd 8 GL Manual SWITCH 2020.indd 8
EN
17-02-20 10:54 17-02-20 10:54