Advertisement
HYUNDAI
8. LED MESSAGES
LIGHT(S) CONDITION
Solid Red Warning! LED
Flashing Red Warning! LED
Slow flashing Red Warning!
LED
+
12V Mode LED
12V/24V Mode LED is on,
four battery charging level
indicator LEDs are flashing
Solid yellow REPAIR LED
+
12V Mode LED
Solid yellow REPAIR LED
+
24V Mode LED
Solid Red Warning! LED
+
Solid yellow SUPPLY LED
Quick flashing Red Warning!
LED
+
Corresponding 12V/24V Mode
LED
Only corresponding 12V/24V
Mode LED
+
Four battery charging level
indicator LEDs are all OFF
Red Warning! LED light
flashed x2, and stop
for 3 sec (repeating)
CAUSE(S)
Reverse Polarity
1) Open-circuit
2) Dirty Battery Posts
3) Dead Battery
4) Output Short Circuit
Charging 24V battery
with 12V Mode
Overheat protection
In 12V REPAIR mode
In 24V REPAIR mode
Overload in SUPPLY Mode
(will automatically shut down for
30 seconds as protection)
Battery cannot be recovered
during charging
In Desulphation Process
Battery cannot be recovered
through Desulphation Process
or Battery cannot be recovered
through Repair Mode
SOLUTION(S)
Exchange the red and black
clamps or ring terminals to the
correct battery posts
1) Connect the red and black
clamps or ring terminals to the
battery posts
2) Clean the battery posts
3) Replace the battery with a new
one immediately
4) Disconnect red and black
output terminals
Please do manually press Mode
button to choose correct charge
mode.
CAUTION: If you use 24V charging
mode for 12V battery,
battery could be damaged
Just wait. After cooling down,
charging will restart
-
-
Disconnect the external device
Replace the battery with
a new one immediately
-
1) Replace with a new battery
2) If battery cannot be recovered
through Desulphation Process, try
REPAIR Mode for recovery
11
Advertisement
